I had this problem earlier this year using some older Hitec digital servos. Interestingly, Channels 1 & 2 on the 6014 receiver output normal signal voltage and work well. <br><br>I sent my servos into Hitec and they changed a resistor to make them work with the lower voltage signal. For some reason they couldn't modify the rudder servo so I plugged it into Channel 1 and re-mapped the outputs from my Tx so the rudder was on Channel 1.<br>
<br>Kludgy but effective. . <br><br><div class="gmail_quote">On Thu, Nov 20, 2008 at 9:15 PM, MKMSG <span dir="ltr"><<a href="mailto:mkmsg@cox.net">mkmsg@cox.net</a>></span> wrote:<br><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
<div bgcolor="#ffffff">
<div><font size="2" face="Arial">I was reading the FAQ section of the Futaba website
when a particular item caught my eye regarding the R6014FS 2.4 receiver.
The FAQ states that <font size="3" face="Times New Roman">the use of non Futaba
digital servos with the R6014FS receiver may be problematic due to the 6014's
lower output voltage of 2.7 volts. Since I do occasionally mix and match
Futaba and JR servos and use the 8 channel 2.4 receiver, I wondered if this
issue was common to all Futaba 2.4 receivers. Here's Futaba's answer: "The
FAQ refers only to the R6014FS receiver, this is the only one that has the lower
voltage." Just thought I'd pass this along in case someone experiences
performance anomalies with the 6014 receivers using other than Futaba
servos.</font></font></div>
<div><font size="2" face="Arial"><font size="3" face="Times New Roman"></font></font> </div>
<div><font size="2" face="Arial"><font size="3" face="Times New Roman"><font size="2" face="Arial">Mike</font></font></font></div>
<div><font size="2" face="Arial"><font size="3" face="Times New Roman"><font size="2" face="Arial">NSRCA 35</font></font></font></div>
<div><br></div></div>
<br>_______________________________________________<br>
NSRCA-discussion mailing list<br>
<a href="mailto:NSRCA-discussion@lists.nsrca.org">NSRCA-discussion@lists.nsrca.org</a><br>
<a href="http://lists.nsrca.org/mailman/listinfo/nsrca-discussion" target="_blank">http://lists.nsrca.org/mailman/listinfo/nsrca-discussion</a><br></blockquote></div><br><br clear="all"><br>-- <br><br>Keith Hoard<br>Collierville, TN<br>
<a href="mailto:khoard@gmail.com">khoard@gmail.com</a><br><br><br>