<div>With the 8ch module, there is also a switch that must be flipped depending on the receiver type. It should be in the 7ch position for 6 or 7 channel receivers, and 8ch for everything else. It will not bind if it is not in the correct position.</div>  <div>&nbsp;</div>  <div>When you press the button on the receiver, you must hold it down for a few seconds.</div>  <div>&nbsp;</div>  <div>Bob R.</div>  <div><BR><BR><B><I>Ron Van Putte &lt;vanputte@cox.net&gt;</I></B> wrote:</div>  <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">I tried one of the Futaba 8-channel module/receiver combinations on <BR>2.4 GHz with my Futaba 9ZAP transmitter. The instructions are <BR>somewhat misleading, at least they are to me . The instructions <BR>talked about pushing the button on the module and then pushing the <BR>button on the receiver. The receiver is supposed to bind to the <BR>transmitter. The question is what indication you get
 when the <BR>receiver is bound to the transmitter. I thought (they don't say what <BR>to look for) I'd see the green LED go from a blinking green to solid <BR>green. That didn't happen and I tried it half a dozen times. Then, <BR>on a whim, I plugged a servo into the receiver before pushing the <BR>receiver button. Low and behold, the LED turned solid green. Later <BR>in the instructions they talk about range checking and say, "After <BR>the radio link has been established (as indicated by either a solid <BR>green LED or a blinking green LED), ....." Huh?! EITHER solid or <BR>blinking green is OK? Now I'm really confused.<BR><BR>Ron Van Putte<BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR></BLOCKQUOTE><BR>