<html><body>
<DIV>Jon,</DIV>
<DIV> </DIV>
<DIV>It is basically a "deadband" issue, which is always a compromise - tighter deadband yields more accurate centering but increases the probability of oscillation (especially with heavy surfaces as has been noted).</DIV>
<DIV> </DIV>
<DIV>Since introduced, there have been some minor changes to 8411, but Horizon should be able to increase the deadband for you.</DIV>
<DIV> </DIV>
<DIV>Regards,</DIV>
<DIV><BR>Dave Lockhart, Team JR</DIV>
<DIV><A href="mailto:DaveL322@comcast.net">DaveL322@comcast.net</A></DIV>
<DIV> </DIV>
<DIV> </DIV>
<BLOCKQUOTE style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">-------------- Original message -------------- <BR>From: JonLowe@aol.com <BR>
<META content="MSHTML 6.00.2900.2963" name=GENERATOR>
<DIV>I'm running a JR 8411sa on rudder on my Aggressor, pull-pull, using the setup that Troy Newman recommends (ss control line cable, NMP links at the servo end, and MK links at the rudder, etc.). For the first 75 or so flights, I had no issues. Then, the servo started self oscillating around neutral, even with the engine not running, on the ground if the rudder stick was bumped. The surface buzzes back and forth about 1/4", until damped out by grabbing the surface. Thinking it was a servo pot going bad, I changed out the servo. After two or three flights, same problem appeared. Then thinking it must be a natural frequency issue in the linkage exciting the feedback loop in the servo, I tightened up on the pull-pull somewhat. It wasn't loose before (these cables, as Troy says, don't stretch at all), but I increased tension somewhat. That helped for about 3 flights, then the problem reappeared. These servos are new 8411's, self co
nverted to SA with a new plastic gear package. I've gone thru the linkage completely, and find no evidence of anything amiss. I've changed nothing in the setup from the first flight. </DIV>
<DIV> </DIV>
<DIV>I believe I read somewhere in the past, about some 8411's doing this because the feedback loop in the servo was too tight, and could be corrected by sending them back to Horizon. Can anyone shed some light on this? I'm about to install an 8611 on rudder, but would like to track down this issue with the 8411s.</DIV>
<DIV> </DIV>
<DIV>Thanks.</DIV>
<DIV> </DIV>
<DIV><FONT size=2 PTSIZE="10">Jon Lowe<BR></FONT></DIV></BLOCKQUOTE></body></html>