<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=iso-8859-1">
<META content="MSHTML 6.00.2900.2873" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial size=2>OK, this isn't exactly a pattern plane, but this
group has a lot of expertise so I thought I'd ask here:</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>I have a Showtime which I've built as an electric
with AXI 5320/28 and Jeti Advance Plus Opto 90 amp ESC with a HVBEC for RX
power. The radio is a JR 9303 TX and PCMS receiver. </FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>The problem is that I am getting some RF
interference. Ground range check is OK to 100 feet with antenna down and
motor off, but when motor is turned on, the rx locks out (PCM) until I
either walk back a few yards closer, or put up the antenna. I have gone
from ppm to pcm RX, put toroid "RF Filters" on the leads from the ESC and both
elevator servo's ( plane designed with elevator servo's mounted in tail with
long leads to RX). I have also braided the wires between the motor and
the ESC<FONT face="Times New Roman" size=3>.</FONT> My next step is to try
a different ESC, but I thought I'd ask here before shelling out a couple of
hundred bucks for a new ESC. </FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Any other thoughts?</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Thanks,</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>George</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV></BODY></HTML>