<div>How about lightweigth spackle if you have to fill it? Not sure how the priming painting will work on it though, but if you cover w/ vinyl you wouldnt have to worry about prime paint, just a scheme to cover all the dents.<BR><BR><B><I>Richard Strickland <richard.s@allied-callaway.com></I></B> wrote:</div> <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">That sounds like the most practical procedure on this thin stuff-I'll give<BR>it a shot. Thanks!<BR><BR>Richard<BR><BR><BR><BR>-----Original Message-----<BR>From: nsrca-discussion-bounces@lists.nsrca.org<BR>[mailto:nsrca-discussion-bounces@lists.nsrca.org] On Behalf Of Bob Kane<BR>Sent: Thursday, April 27, 2006 1:01 PM<BR>To: NSRCA Mailing List<BR>Subject: Re: [NSRCA-discussion] Brio 2nds<BR><BR>Depending on the dent, see if you can work it out with<BR>some heat before filling it. I know this worked on<BR>another blowout sale Brio.<BR><BR>I don't have the exact
procedure, but you use a hair<BR>dryer or heat gun to gently heat the affected area and<BR>push it back to shape.<BR><BR><BR>--- Richard Strickland <RICHARD.S@ALLIED-CALLAWAY.COM><BR>wrote:<BR><BR>> I managed to get one of the slightly dented Brios<BR>> that will take some<BR>> filler. The composite material is so thin, however<BR>> I'm thinking auto filler<BR>> will be too hard to sand compared to the structure.<BR>> (I don't want to<BR>> penetrate the gel-cote as there just isn't much<BR>> there) How about using<BR>> model filler and then hardening it up with CA? Any<BR>> thoughts? Suggestions?<BR>><BR>> Richard<BR>><BR>><BR>> _______________________________________________<BR>> NSRCA-discussion mailing list<BR>> NSRCA-discussion@lists.nsrca.org<BR>><BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR>><BR><BR><BR>Bob
Kane<BR>getterflash@yahoo.com<BR><BR>__________________________________________________<BR>Do You Yahoo!?<BR>Tired of spam? Yahoo! Mail has the best spam protection around<BR>http://mail.yahoo.com<BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR><BR><BR><BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR></BLOCKQUOTE><BR><p>
<hr size=1>How low will we go? Check out Yahoo! Messenger’s low <a href="http://us.rd.yahoo.com/mail_us/taglines/postman8/*http://us.rd.yahoo.com/evt=39663/*http://voice.yahoo.com"> PC-to-Phone call rates.