[NSRCA-discussion] Esc check

[Ronald Van Putte]

Good!  My electronics expertise extends only as far as direct current, because it’s like water flowing.  Alternating current is Black Magic!

Ron


> On Dec 8, 2017, at 6:29 PM, atwooddon at aol.com wrote:
> 
> Ron, that is entirely too logical....
> 
> Don
> 
> -----Original Message-----
> From: Ronald Van Putte via NSRCA-discussion <nsrca-discussion at lists.nsrca.org>
> To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
> Sent: Fri, Dec 8, 2017 4:49 pm
> Subject: Re: [NSRCA-discussion] Esc check
> 
> I’m surprised that the electronic gurus out there haven’t responded yet, So I, a mere aeronautical engineer, will boldly respond. My technique to evaluate a questionable ESC is attach it to a good receiver and a known good 10S motor. Then I attach a 3-5 cell lipo pack and try to run the motor. The small number of cells precludes the motor from going “bonkers". BTW, "bonkers" is a technical term for “not behaving as expected”. If I get the expected result, I will use a 10S pack and reevaluate. OK you lurkers: Fire away! Ron Van Putte > On Dec 8, 2017, at 1:46 PM, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org <mailto:discussion at lists.nsrca.org>> wrote: > > Is there any way to check and make sure an esc is still ok? YEP 80HV > > Jas iP > _______________________________________________ > NSRCA-discussion mailing list > NSRCA-discussion at lists.nsrca.org <mailto:discussion at lists.nsrca.org> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion <http://lists.nsrca.org/mailman/listinfo/nsrca-discussion>_______________________________________________ NSRCA-discussion mailing list NSRCA-discussion at lists.nsrca.org <mailto:discussion at lists.nsrca.org> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion <http://lists.nsrca.org/mailman/listinfo/nsrca-discussion>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20171209/c375bad8/attachment.html>