[NSRCA-discussion] 10s LiPo Charger Recommendation

[Dr. Michael Harrison, DDS]

lol

-----Original Message-----
From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Earl Haury via NSRCA-discussion
Sent: Thursday, October 08, 2015 8:26 AM
To: Budd Engineering; General pattern discussion
Subject: Re: [NSRCA-discussion] 10s LiPo Charger Recommendation

Jerry

Hard to beat the iChargers. The CellPros taught me that a fuse between the pack & charger is a good investment! No issues with 3010b iChargers  (about
3000 charges over 5 years or so). They  will report cell IR / voltage and charge a 10S pack at 2C with a 24v supply without breaking a sweat. The newer 4010 can handle 2x10S and displays data from both packs simultaneously. They don't meet your criteria of charging through the balance leads, but haven't really found that to an issue as the balancing system works fine. Can't really comment on service, haven't needed any (that should jinx me).

Earl

-----Original Message-----
From: Budd Engineering via NSRCA-discussion
Sent: Thursday, October 08, 2015 4:59 AM
To: List NSRCA-list
Subject: [NSRCA-discussion] 10s LiPo Charger Recommendation

Hi all, I’m in need of some advice/suggestions for a new LiPo charger for 10s packs.

For the past several years I’ve used CellPro-10S chargers with good results. 
However recently one of my CellPro-10s' emitted the dreaded “magic smoke” 
when I connected a 10s pack for charging.  This also happened at the Nats 3 years ago, fortunately Mike M. from F3AU was there with inventory and I was able to purchase a replacement charger and press on.  However, after having a second one give up the ghost a few weeks ago (and after not many charge cycles - I don’t fly very much), I’m interested in exploring other options.


To try to add some focus to this here’s my search constraints:

1.  It must be able to charge each cell individually through the balance connector, and give me a relative readout of each cell’s condition compared to the other 9 cells.

2.  I’m not interested in chargers that have separate balancers from the charger (e.g. like the TP1010C).

3.  Reliability and value are important, as is ease of use.

4.  Cost no more than a replacement CellPro 10XP (<$180), unless a single charger can charge two 10s packs simultaneously, then I’d consider spending a bit more.

5.  Customer service matters, if I can buy it through F3A Unlimited, that would be a PLUS.


With this in mind does anyone have a suggestion for what chargers I should 
consider?


I don’t get out much these days so it’s difficult to see what everyone’s 
using that works well.  So I really do appreciate everyone’s help with this.

Thx, Jerry
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion