[NSRCA-discussion] Battery discharge/storage question

Keith Hoard klhoard at hotmail.com
Wed May 8 11:35:04 AKDT 2013


Yessir!!

Sent from my iPhone

On May 8, 2013, at 14:25, "Scott McHarg" <scmcharg at gmail.com> wrote:

> That's why they give you load agents, operations agents and a FMC Keith.
> 
> 
> On Wed, May 8, 2013 at 2:17 PM, Keith Hoard <klhoard at hotmail.com> wrote:
>> Van Putte told me there would be no math. 
>> 
>> Sent from my iPhone
>> 
>> On May 8, 2013, at 13:46, "Dave Harmon" <k6xyz at sbcglobal.net> wrote:
>> 
>>>  
>>> 
>>> At the end of every flying session, I leave the field with the batteries in whatever state of charge that they have.
>>> 
>>> I don’t do a storage charge at the field.
>>> 
>>> I do the storage charge at home.
>>> 
>>>  
>>> 
>>> If I am going to fly the next day or in a few days….less than a week, I do not discharge the already charged batteries….but I DO top them off at the field the next time out.
>>> 
>>> Today’s chargers usually go into the balance mode immediately when charging a previously charged battery so I don’t believe there is a problem topping off a previously charged battery.
>>> 
>>>  
>>> 
>>> Before I leave for the field, I charge all batteries that are discharged or in storage charge.
>>> 
>>> If I have several flying sessions in a week or so I will NOT put any discharged batteries in storage charge….
>>> 
>>> Then I charge them just before I leave home on the next day I go flying.
>>> 
>>> If I know I am not going to fly for several days then I DO put discharged batteries in storage charge….AND discharge charged batteries low enough to put into storage charge.
>>> 
>>>  
>>> 
>>>  
>>> 
>>> If I need to discharge any batteries I do it with a 17 ohm 100w Dale resistor.
>>> 
>>> I made a 12” heavy zip cord lead with alligator clips on one end and a matching connector for the battery on the other end.
>>> 
>>> I use a Fluke DVM across the resistor to monitor the voltage and I discharge down to about 35 volts.
>>> 
>>> Then I immediately do a storage charge.
>>> 
>>> I might not have to take them down to 35 volts but the battery must be below the storage charge voltage to get the charger into the storage mode.
>>> 
>>>  
>>> 
>>> If you do the math….the discharge on a fully charged battery is about 2.4A and the resistor is running within its wattage range.
>>> 
>>>  
>>> 
>>> Dave Harmon
>>> 
>>> NSRCA 586
>>> 
>>> K6XYZ[at]sbcglobal[dot]net
>>> 
>>> Sperry, Ok.
>>> 
>>>  
>>> 
>>> From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Scott McHarg
>>> Sent: Wednesday, May 08, 2013 1:06 PM
>>> To: General pattern discussion
>>> Subject: Re: [NSRCA-discussion] Battery discharge/storage question
>>> 
>>>  
>>> 
>>> I got scolded not too long ago for even suggesting it by a ThunderPower rep.  I wanted to top off because after a week, one of my packs had dropped down to like 94% (yes it was an older pack and had a little over 180 cycles on it).  I was told that topping off "could" cause damage to the packs immediately regardless of age.  It was a fairly stern warning.  Honestly, I didn't ask more because I was already hanging my head from the scolding.  I just said "Yes sir, sir".  :)
>>> 
>>>  
>>> 
>>> On Wed, May 8, 2013 at 1:00 PM, Atwood, Mark <atwoodm at paragon-inc.com> wrote:
>>> 
>>> Okay, I'll bite. Why don't you want to top off the charge? I know a lot of people who insist on doing this even if they just flew the day before.
>>> 
>>> Sent from my average intelligence  phone
>>> 
>>> 
>>> On May 8, 2013, at 1:44 PM, "Scott McHarg" <scmcharg at gmail.com<mailto:scmcharg at gmail.com>> wrote:
>>> 
>>> I haven't seen any issues with a battery left a full charge for a week but I wouldn't recommend longer at full charge.  Just make sure that you DO NOT top off the charge prior to flying.  I have started doing what Keith does as well which eliminates all concerns.  The worst part is having to wait at the field while you bring that battery back up to 50%.  Last one out has to lock the gates.
>>> 
>>> 
>>> On Wed, May 8, 2013 at 11:23 AM, Keith Hoard <klhoard at hotmail.com<mailto:klhoard at hotmail.com>> wrote:
>>> I take my batts to the field at 50% and leave the field at 50% charge. If I can't do that, then I discharge when I get home. My batts seem to last a long time.
>>> 
>>> The (dis)charger is supposed to get hot, that is where the energy from the battery is going - into the heat sink. That's Ok, my PL 8 gets hot too.
>>> 
>>> The PL8 can only discharge 100 watts by itself, but can do much higher if it is using "regenerative" discharge - dumping your LiPo's charge back into a lead acid battery. I don't know if the 10X has that capability or not.  Otherwise I'd just keep using the low discharge rate, or plan your flying day to end with a storage charge.
>>> 
>>> Wow, that was a lot of typing to do on a phone!!
>>> 
>>> Sent from my iPhone
>>> 
>>> On May 8, 2013, at 11:15, "Bob Kane" <getterflash at yahoo.com<mailto:getterflash at yahoo.com>> wrote:
>>> 
>>> I have had to abort a couple of planned flying sessions so far this spring due to weather.  I have read that lipos should not be left at full charge for any significant length of time. So what is a significant length of time?
>>> 
>>> Hours?  Days? Weeks?
>>> 
>>> My Turnigy 10XS charger has a discharge/storage mode, but the maximum discharge current is 1 amp. It takes a couple of hours to bring a 10S pack down to storage level, and the charger gets pretty warm(!) during the discharge.  Up to now I have only worried about discharging the pack for long term storage.
>>> 
>>> If leaving the cells fully charged for more than a day or so is bad, I am considering building a dedicated discharger, there are some pretty simple yet effective designs on RCU.
>>> 
>>> Bob Kane
>>> getterflash at yahoo.com<mailto:getterflash at yahoo.com>
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>> 
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>> 
>>> 
>>> 
>>> --
>>> Scott A. McHarg
>>> Sr. Systems Engineer - Infrastructure
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>> 
>>> 
>>> 
>>> 
>>>  
>>> 
>>> -- 
>>> Scott A. McHarg
>>> Sr. Systems Engineer - Infrastructure
>>> 
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>> 
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> 
> 
> -- 
> Scott A. McHarg
> Sr. Systems Engineer - Infrastructure
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20130508/cd95d45d/attachment.html>
-------------- next part --------------
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


More information about the NSRCA-discussion mailing list