[NSRCA-discussion] Large 6-inch clear heatshrink tube source

[rcmaster199 at aol.com]

How about a piece of UltraKote? About as thin and light as it gets. Another possibility, search for a drink bottle shrink tube. That's typically made from PET also but it's a bit thin...doubled up it should be fine

regards

MattK



-----Original Message-----
From: Bob Pastorello <rpasto513 at gmail.com>
To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
Sent: Tue, Aug 20, 2013 7:05 am
Subject: Re: [NSRCA-discussion] Large 6-inch clear heatshrink tube source



Search results from a source I use for a variety of things.
http://www.aliexpress.com/wholesale?SearchText=shrink+tubing+150mm&catId=0&initiative_id=SB_20130820030119




On Tue, Aug 20, 2013 at 2:43 AM, P & A Hobbies <PnAHobbies at sbcglobal.net> wrote:

Hi, All,

I am in need of at least 6" inside diameter heat shrink tube to wrap a 10S 5000mAh pack.
Does anyone know a good source for it?
It should be thin after shrinking.  Most that I found were at least 1mm thick after shrink down to 6" diameter.

Any suggestion?

Thanks,

Ihncheol

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion




-- 
Bob Pastorello
rpasto513 at gmail.com 

_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20130820/c2ad5ad8/attachment.html>