[NSRCA-discussion] Looking for a pattern plane

John Gayer jgghome at comcast.net
Wed May 9 09:45:20 AKDT 2012


Ron,
Did you use the same input plug for both lipos? If so, all I can say is 
that it only costs $14. If not, there may be some frontend circuitry in 
there that somehow establishes a secondary and a primary battery input 
to the single regulator.
John

On 5/9/2012 8:53 AM, Ronald Van Putte wrote:
>
> When I did the test, only one lipo at a time was hooked up to the 
> separate switch/regulator inputs.  The output voltages were different, 
> which I attributed to tolerances in two regulators within the device. 
>  If there really is only one regulator in the switch/regulator, I 
> cannot understand why there's a difference in output voltages.
>
> Ron Van Putte
>
> On May 8, 2012, at 8:12 PM, John Gayer wrote:
>
>> You are still only reading the regulator output from one of the lipos 
>> and both outputs would have to be the same.
>> Ed is saying the single regulator dual outputs are not independent as 
>> they would be if you used two tech-aero or jaccio regulators.
>> Sounds like a good system to have on a smaller cheaper aircraft than 
>> our 2 meter pattern planes. Gives you redundant batteries but not 
>> redundant power systems. You are now reliant on a single point of 
>> failure 14 dollar regulator.
>> John
>> On 5/8/2012 5:01 PM, Ronald Van Putte wrote:
>>> Any comments from Jim Oddino?
>>>
>>>
>>> On May 8, 2012, at 5:51 PM, Ed Alt wrote:
>>>
>>>> Not necessarily.
>>>> *From:* Ronald Van Putte <mailto:vanputte at cox.net>
>>>> *Sent:* Tuesday, May 08, 2012 6:38 PM
>>>> *To:* General pattern discussion 
>>>> <mailto:nsrca-discussion at lists.nsrca.org>
>>>> *Subject:* Re: [NSRCA-discussion] Looking for a pattern plane
>>>> Hmmmm.  I wonder why I measure different voltages when I switch on 
>>>> the two 2S lipo batteries at different times.  If it had a single 
>>>> regulator, I would think the output voltage would be the same, no 
>>>> matter which battery was chosen.
>>>> Ron
>>>> On May 8, 2012, at 5:25 PM, Ed Alt wrote:
>>>>
>>>>> It's actually a dual output single regulator that can switch 
>>>>> between two power sources.  It provides two leads from the same 
>>>>> internal source, so only the battery side of things has any 
>>>>> redundancy.
>>>>> Ed
>>>>> *From:* Ronald Van Putte <mailto:vanputte at cox.net>
>>>>> *Sent:* Tuesday, May 08, 2012 6:16 PM
>>>>> *To:* General pattern discussion 
>>>>> <mailto:nsrca-discussion at lists.nsrca.org>
>>>>> *Subject:* Re: [NSRCA-discussion] Looking for a pattern plane
>>>>> Ron - It is a dual regulator/switch which allows you to hook up 
>>>>> two lipo batteries and have them separately regulated to 5.9 volts 
>>>>> and use one or both of the outputs.  Look here:
>>>>> http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=16811
>>>>> I sell them for under $20.
>>>>> Ron
>>>>> On May 8, 2012, at 4:42 PM, ronclark tds.net <http://tds.net/> wrote:
>>>>>
>>>>>> Hey Ron, rusty and old, but I'm going to give it another try. 
>>>>>> Emory Schroeter told me about a dual regulator for the receiver 
>>>>>> pack that you are selling, what's the scoop?
>>>>>> Ron
>>>>>>
>>>>>> On Fri, May 4, 2012 at 5:41 AM, Ronald Van Putte 
>>>>>> <vanputte at cox.net <mailto:vanputte at cox.net>> wrote:
>>>>>>
>>>>>>     Hey Ron:  Buy it and our old fingers can duke it out again. 
>>>>>>     I look forward to having you on the contest trail again.
>>>>>>     Ron
>>>>>>     On May 3, 2012, at 11:24 PM, AC Glenn wrote:
>>>>>>
>>>>>>>     Hey Ron I have a Ca Models Visa for sale ready to fly and
>>>>>>>     would be more than happy to drive it down to your place.
>>>>>>>
>>>>>>>     Sent from my iPhone
>>>>>>>
>>>>>>>     On May 3, 2012, at 7:39 PM, "ronclark tds.net
>>>>>>>     <http://tds.net/>" <ronclark at tds.net
>>>>>>>     <mailto:ronclark at tds.net>> wrote:
>>>>>>>
>>>>>>>>     I'm looking for a used pattern plane. It's been about 10
>>>>>>>>     years since my last contest,   and I want to give these old
>>>>>>>>     fingers another chance. I'm looking for a fixed gear 2m
>>>>>>>>     design, and plan to do an electric setup. I can convert a
>>>>>>>>     methanol burner if necessary.  I live in Nashville,tn.,
>>>>>>>>     avoiding shipping would be good. Please reply off line to:
>>>>>>>>     ronclark at tds.net <mailto:ronclark at tds.net>
>>>>>>>>     Thanks...Ron
>>>>>>>>     _______________________________________________
>>>>>>>>     NSRCA-discussion mailing list
>>>>>>>>     NSRCA-discussion at lists.nsrca.org
>>>>>>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>>>>     _______________________________________________
>>>>>>>     NSRCA-discussion mailing list
>>>>>>>     NSRCA-discussion at lists.nsrca.org
>>>>>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>>>
>>>>>>     _______________________________________________
>>>>>>     NSRCA-discussion mailing list
>>>>>>     NSRCA-discussion at lists.nsrca.org
>>>>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>>>
>>>>>>
>>>>>> _______________________________________________
>>>>>> NSRCA-discussion mailing list
>>>>>> NSRCA-discussion at lists.nsrca.org 
>>>>>> <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>> ------------------------------------------------------------------------
>>>>> _______________________________________________
>>>>> NSRCA-discussion mailing list
>>>>> NSRCA-discussion at lists.nsrca.org 
>>>>> <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>> _______________________________________________
>>>>> NSRCA-discussion mailing list
>>>>> NSRCA-discussion at lists.nsrca.org 
>>>>> <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>
>>>> ------------------------------------------------------------------------
>>>> _______________________________________________
>>>> NSRCA-discussion mailing list
>>>> NSRCA-discussion at lists.nsrca.org 
>>>> <mailto:NSRCA-discussion at lists.nsrca.org>
>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>> _______________________________________________
>>>> NSRCA-discussion mailing list
>>>> NSRCA-discussion at lists.nsrca.org 
>>>> <mailto:NSRCA-discussion at lists.nsrca.org>
>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>
>>>
>>>
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org 
>> <mailto:NSRCA-discussion at lists.nsrca.org>
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20120509/25269713/attachment.html>


More information about the NSRCA-discussion mailing list