[NSRCA-discussion] Plettenberg 30-10 evo and Jeti ESC

[Jon Lowe]

Nah, let's talk about snaps and spins instead!


Jon



-----Original Message-----
From: Ronald Van Putte <vanputte at cox.net>
To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
Sent: Fri, Mar 16, 2012 2:53 pm
Subject: Re: [NSRCA-discussion] Plettenberg 30-10 evo and Jeti ESC


I hope we're not going to get into a Futaba vs JR p---ng contest.


Ron


On Mar 16, 2012, at 2:38 PM, Phil S. wrote:


Jon, how else would they boost their equipment sales?  If the new stuff was backwards compatible (as, BTW, DSMX is with DSM2) everyone would keep using their old, perfectly good stuff instead of replacing it with new...

On 3/16/2012 12:22 PM, Jon Lowe wrote: 
Is this worth a shot?
 
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8356
 
It's disappointing that after the various radio manufacturers standardized wiring, signal timing, etc. for servos, that Futaba would move, again, in this direction.  They should make clear in their advertising that their new receivers may not be compatible with equipment you already have.  Should be considered a design defect.  All this does is hurt the customers.


Jon

-- 
hil Spelt, KCRC President
MA 1294 Scientific Leader Member
PA 177 Board Member
865) 435-1476v, (865) 604-0541c
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20120316/d05e2cf2/attachment.html>