[NSRCA-discussion] Wire Tubes

[John Gayer]

  Tape legal pad sheets together to get the length you want, roll the 
sheets on an appropriate size dowel and use scotch tape to hold it 
together. If the appearance is important, lightly spray it flat black. 
Install with a  dab of gorilla glue every 6 inches or so.

John

On 10/18/2010 8:21 AM, Jerry Stebbins wrote:
> Bryan, might look at the thin wall carbon tubes that CST have listed. 
> Large soda straws work ok--but not with connectors.
> Jerry
> ----- Original Message ----- From: <shinden1 at cox.net>
> To: <nsrca-discussion at lists.nsrca.org>
> Sent: Sunday, October 17, 2010 11:29 PM
> Subject: [NSRCA-discussion] Wire Tubes
>
>
>> Guys,
>> I looking for a source for Light tubing to run Elevator servo wires 
>> to the back of an AIrplane.
>> Does anyone know where I can get this?
>>
>> Bryan
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>