[NSRCA-discussion] titanium and aluminum screws

Earl Haury ejhaury at comcast.net
Mon May 17 16:58:38 AKDT 2010


Jason

Lunsford is a good source for Ti capscrews in both inch & metric. http://www.lunsfordracing.com/mm5/merchant.mvc    I don't believe that they have threaded rod - I use SS from McMaster, good quality and reasonably lite.

For Al try Fastener Express - neat anodized colors available also. http://www.fastener-express.com/

Earl
  ----- Original Message ----- 
  From: brett terry 
  To: General pattern discussion 
  Sent: Monday, May 17, 2010 7:37 PM
  Subject: Re: [NSRCA-discussion] titanium and aluminum screws


  Jason,
  www.smallparts.com and www.mcmaster.com are good places to start.  Unfortunately they don't seem to carry anything smaller than 8-32 in Ti.

  Good luck!

  Brett


  On Mon, May 17, 2010 at 5:20 PM, J Shu <jshulman at cfl.rr.com> wrote:

    I don't remember if it was here or not, but I'm looking for 6/32 titanium threaded rod, screws... and aluminum servo screws and 4/40 and 6/32 screws. Anyone know where I can find them? Also 4mm titanium or aluminum screws.

    Regards,
    Jason
    http://jshulman.weebly.com/

    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion





------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100518/eee0770f/attachment.html>


More information about the NSRCA-discussion mailing list