[NSRCA-discussion] carbon plate cutting

[Koenig, Tom]

Jason-find someone with a water jet cutter, I'd imagine that would do the best. I have a CNC router and mill, but I'd imagagine tool bits would not last too long on solid carbon. Never tried on a Laser, I doubt it would cut carbon????

I'm sure someone out there has access to some good gear...or knows how to use it better than I!

Tom

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of J Shu
Sent: Monday, 3 May 2010 2:22 PM
To: NSRCA
Subject: [NSRCA-discussion] carbon plate cutting

Hi All,

I'm looking for anyone that can cut some carbon plate (3/16"?) into control horns, like the stuff from Composite-ARF.  Anyone know someone that can do it? I'll be making the CAD file this week for it.

Regards,
Jason
http://jshulman.weebly.com/

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

************************************************************************
*PLEASE NOTE* This email and any attachments may
be confidential. If received in error, please delete all
copies and advise the sender. The reproduction or
dissemination of this email or its attachments is
prohibited without the consent of the sender.

WARNING RE VIRUSES: Our computer systems sweep
outgoing email to guard against viruses, but no warranty
is given that this email or its attachments are virus free.
Before opening or using attachments, please check for
viruses. Our liability is limited to the re-supply of any
affected attachments.

Any views expressed in this message are those of the
individual sender, except where the sender expressly,
and with authority, states them to be the views of the
organisation.
************************************************************************