[NSRCA-discussion] Mostly Sold...RE: More motors....RE: (2) Hacker A60-24S OutrunnersFor Sale (SOLD!)

[Dave]

All sold except for the Cyclon 160.

Thanks!

Dave



-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Dave
Sent: Monday, February 22, 2010 12:41 PM
To: 'General pattern discussion'
Subject: [NSRCA-discussion] More motors....RE: (2) Hacker A60-24S
OutrunnersFor Sale (SOLD!)

Following Jerry's post, I also have an A60-24S (and some other motors) for
sale -

Hacker A60-24S V2, ~25 runs, never crashed, minor cosmetic scratches on
exterior.  $60 plus shipping.

Hacker A60-22S V2, ~25 runs, never crashed, minor cosmetic scratches on
exterior.  $60 plus shipping.

Hacker A60-22S V1, ~25 runs, never crashed, minor cosmetic scratches on
exterior.  $50 plus shipping.

Cyclon 160.  This is NOT the F3A version of the motor.  This motor is 289
KV, and suitable for 16-17" props (10-13" pitch) on 10S (~8500-9000 RPM),
and 18-19" props on 8S (~7,000 RPM).  20 oz, backplate mount.  Very smooth
and quiet.  $100 plus shipping. 

Plettenberg 30-10 "P20".  This is a higher KV (255) version of the original
30-10.  I ran it around 60-70 amps on 10S with 17" props ~8000 RPM.  KV is
high enough that 8S setups would also likely work well.  19 oz, backplate
mount.  Very smooth and quiet.  $125 plus shipping.

Please let me know if any questions.

Regards,

Dave Lockhart
DaveL322 at comcast.net



-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Jerry Budd
Sent: Saturday, February 20, 2010 9:33 AM
To: CA, AZ, HI, NV, UT
Cc: NSRCA-list List
Subject: [NSRCA-discussion] (2) Hacker A60-24S Outrunners For Sale (SOLD!)

The Hacker A60's have been sold.

Thx, Jerry

Jerry Budd
jerry at buddengineering.com


On Feb 19, 2010, at 8:23 AM, Budd Engineering wrote:

> I have (2) used Hacker A60-24S outrunners for sale.
>
> #1 has a full season on it with no problems and is in great  
> operating condition with minor cosmetic scratches on the exterior of  
> the can body.
>
> #2 is low time but was crashed and repaired to new operating  
> condition at the factory.  It also has some minor cosmetic scratches  
> on the can body.
>
> The motors have performed flawlessly and run very cool when provided  
> a proper amount of cooling air.
>
> The motors run extremely smooth, and turn an APC 20.5-14 at around  
> 6k rpm with a decent battery.  They would make a great entry level  
> setup for someone getting into electric in the lower classes, or  
> would provide scary performance for a 110-sized plane.
>
> $75 each + shipping, or $135 for both, shipped.
>
> Budd Engineering
> jerry at buddengineering.com
> http://www.buddengineering.com
>
> _______________________________________________
> NSRCA-dist7 mailing list
> NSRCA-dist7 at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-dist7

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion