[NSRCA-discussion] Source for vacuum bagging equipment?

[Woodward, Jim R (US SSA)]

Thanks guys!!

Thank You,

Jim Woodward
Program Manager II
BAE Systems Technology Solutions & Services
210 Aviation Way Albertville, AL 35950
Office: (256) 894-4209
Mobile: (256) 677-8819

From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of rcmaster199 at aol.com
Sent: Monday, June 21, 2010 1:00 PM
To: nsrca-discussion at lists.nsrca.org
Subject: Re: [NSRCA-discussion] Source for vacuum bagging equipment?

ACP also carries large diameter nylon (tough) bagging material, up to 60" wide. The 36" wide material is large enough to accommodate both panels of a wing, side by side. Regulated vacuum source needs to be continuous in these set-up, until the epoxy sets. Do get the extra sealing rods they sell...very simple and reusable. If the epoxy will contact the bag, do get the peel ply stock. Don't get the breather...regular paper towels work great as breather material

The larger pumps will often pull considerable vacuum, 25" Hg or higher. Auto regulation isn't necessary-- a simple bleeder valve works great. The small pump indicated at the ACP site only pulls 8"Hg (good enough for wing skinning but not high enough for firwall lamination for example)

For small stuff like bulkheads and firewalls, hard to beat the convenience of a FoodSaver Vacuum Food Sealer system or similar. The bags come in widths up to 10" by at least 50 feet long. This set-up differs from the other vacuum set-ups in that the bag seals after vacuum is pulled. The vacuum source requirement is temporary. The amount of vacuum is moderate at around 18" Hg

regards

Matt Kebabjian


-----Original Message-----
From: Jay Marshall <lightfoot at sc.rr.com>
To: 'General pattern discussion' <nsrca-discussion at lists.nsrca.org>
Sent: Mon, Jun 21, 2010 1:38 pm
Subject: Re: [NSRCA-discussion] Source for vacuum bagging equipment?
Jim, try http://www.acp-composites.com/home.php?cat=4732

Jay Marshall
-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org<mailto:nsrca-discussion-bounces at lists.nsrca.org> [mailto:nsrca-discussion-bounces at lists.nsrca.org<mailto:nsrca-discussion-bounces at lists.nsrca.org?>] On Behalf Of Woodward, Jim R (US SSA)
Sent: Monday, June 21, 2010 1:30 PM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Source for vacuum bagging equipment?

Hi Guys,

Does anyone have a source for vacuum bagging setup/equipment?
Thanks,
Jim

Thank You,

Jim Woodward
Program Manager II
BAE Systems Technology Solutions & Services
210 Aviation Way Albertville, AL 35950
Office: (256) 894-4209
Mobile: (256) 677-8819


_______________________________________________ NSRCA-discussion mailing list NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100621/6b2df8f8/attachment.html>