[NSRCA-discussion] Hatch latch or screws?
colin chariandy
cchariandy at yahoo.ca
Wed Dec 29 15:51:44 AKST 2010
Yep..C1. Even if I add a T later it will probably be just aft of the canopy.
Should the latch be on the canopy or the fuse for best effectiveness?
Colin.
________________________________
From: "verne at twmi.rr.com" <verne at twmi.rr.com>
To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
Sent: Wed, December 29, 2010 3:37:34 PM
Subject: Re: [NSRCA-discussion] Hatch latch or screws?
Colin,
BTW, I'm assuming you're building the Xigres C-1 without a canalizer. I don't
think you'd be able to mount a hatch latch in the normal position at the top
rear of the canopy if you're using the canalizer that comes on a C-2. I would
think the canalizer would cause enough movement to require the use of screws to
prevent ANY movement of the canopy.
Verne
---- verne at twmi.rr.com wrote:
=============
Colin,
The red hatch latch from Hobby Lobby is the best I've found and I've never had a
failure with one. The other ones eith have a pin that's too short or spring
tension that's too soft or too hard. I'm building a Xigres as well and it'll
have the red latch in it. The front will have two, 1/8" aluminum pins and I'll
have either one or two lite ply tabs from the bottom of the canopy that slide
into slots cut into the flange on the fuse that the canopy sits on. The tabs are
there to keep the canopy from moving from side to side. The front pins and the
hatch latch will keep it from blowing off.
Hope this helps,
Verne Koester
---- colin chariandy <cchariandy at yahoo.ca> wrote:
=============
I'm finishing the canopy on my Xigris and havent decided between at least one
4-40 screw at the aft top or a hatch latch.
I've always used 2 screws....would'nt dream of a latch with a glow model.
However, this is e-powered. I still hear and read occasionally of departing
canopies and am a little uncertain about the security of a hatch latch.
Is a single hatch latch reliable or should I stick with 4-40s?
Thanks for any feedback.
Colin.
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20101230/3d8ab3b6/attachment.html>
More information about the NSRCA-discussion
mailing list