[NSRCA-discussion] JR9303 Throttle cut/hold in airplane software for e-power

[Xavier Mouraux]

I use a simple mix and the gear switch on a DX7 so it should work similarly on the 9303. The mix is trottle-trottle with -125 travel and also -125 offset. Setting the offset was important to make it work. The switch stops the motor at any position of the trottle.

Xavier



--- On Fri, 3/20/09, Ihncheol Park <pnahobbies at sbcglobal.net> wrote:

> From: Ihncheol Park <pnahobbies at sbcglobal.net>
> Subject: [NSRCA-discussion] JR9303 Throttle cut/hold in airplane software for e-power
> To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
> Date: Friday, March 20, 2009, 9:30 AM
> Ok.  I have a question to
> all those who fly E-power.
> I've been flying a little of e-powered planes, but
> mostly foamy and small ones.
> Now going with 90 size before starting 2m.
>  
> Is there any way to set throttle cut/hold in
> Airplane software for entire range of the throttle?
> I've mixed throttle to throttle on a
> switch to 0 in all 5 point.  It works on idle, but
> not if I move the throttle stick more than 1/4
> throttle.  Motor still turns. 
>  
> Am I missing something?
>  
> I don't want that 19 + inch props turn without my
> approval!
>  
> Thanks,
>  
> Ihncheol
> -----Inline Attachment Follows-----
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion