[NSRCA-discussion] Carbon Fiber Landing Gear

[Derek Koopowitz]

Excellent Lance!  Luckily I still have 2 sets of Bolly but would really like
to have spares because these two are going into planes now.  My preference
is for a set that matches the Bolly F3A long gear. 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of
aeroslave at tx.rr.com
Sent: Thursday, January 15, 2009 12:06 PM
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] Carbon Fiber Landing Gear

Dear Pattern Dudes

Some time ago I had sent an email asking what was the level of interest
about AeroSlave designing and fabricating for sale a new carbon fiber
landing gear. We got a decent response. In light of the fact that it appears
all the sources of supply have exited the business, and the fact that
crappy-hard landings by more than a few flyers will continue, helping to
boost the market, AeroSlave will investigate designing and fabrication a
"Pattern" landing gear-meaning designed for a 5Kg max plane. Lance and I
have some ideas based on what we have seen from other suppliers and we will
begin with these ideas. Personally I thought the ES gear were very good.

What I can tell you is that the gear will be:

-American made
-Aerospace Prepreg/ Autoclave fabricated -Will carry a normal use warranty
-As light as we can make it, with structural integrity

This may take 6 months so buy what you can now.

Comments on likes and dislikes on pattern gear would be appreciated as we
tackle the design phase.
--
AeroSlave
4408 Elmhurst Dr
Plano, TX  75093
www.aeroslave.com
PayPal: aeroslave at tx.rr.com
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion