[NSRCA-discussion] Snap rolls

[krishlan fitzsimmons]

Did you put the elevator upside down Ed? You have to make sure you put the non scraping side down.. 



Chris          

--- On Mon, 9/22/08, Ed Alt <ed_alt at hotmail.com> wrote:
From: Ed Alt <ed_alt at hotmail.com>
Subject: Re: [NSRCA-discussion] Snap rolls
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Date: Monday, September 22, 2008, 10:03 PM



 
 

I just tried that. Something doesn't look 
exactly right and the elevator is scraping the workbench now.  What am I 
doing wrong?  
 
Ed

  ----- Original Message ----- 
  From: 
  JShulman 
  
  To: General pattern discussion 
  
  Sent: Monday, September 22, 2008 11:30 
  PM
  Subject: Re: [NSRCA-discussion] Snap 
  rolls
  

  swap rudder 
  with elevator
   
  Regards,
Jason
www.jasonshulman.com
www.shulmanaviation.com
www.composite-arf.com

  
    -----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org 
    [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Bob 
    Wilson
Sent: Tuesday, September 23, 2008 12:24 AM
To: 
    General pattern discussion
Subject: [NSRCA-discussion] Snap 
    rolls


    
    I'm probably opening this up for lots of discussion, but what is the 
    correct technique for a snap?
     
    For an inside snap, I apply rudder a fraction before (same direction) 
    aileron and up elevator.
    For an outside snap, I apply rudder a fraction before opposite aileron 
    and down elevator.
     
    Problem is, I watch the big boys do snaps on my TOC videos and 
    mine look so raggedy-ass.
  
  

  _______________________________________________
NSRCA-discussion 
  mailing 
  list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080923/10786aca/attachment.html>