[NSRCA-discussion] Snap rolls

[Ed Alt]

I just tried that. Something doesn't look exactly right and the elevator is scraping the workbench now.  What am I doing wrong?  

Ed
  ----- Original Message ----- 
  From: JShulman 
  To: General pattern discussion 
  Sent: Monday, September 22, 2008 11:30 PM
  Subject: Re: [NSRCA-discussion] Snap rolls


  swap rudder with elevator

  Regards,
  Jason
  www.jasonshulman.com
  www.shulmanaviation.com
  www.composite-arf.com

    -----Original Message-----
    From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Bob Wilson
    Sent: Tuesday, September 23, 2008 12:24 AM
    To: General pattern discussion
    Subject: [NSRCA-discussion] Snap rolls


    I'm probably opening this up for lots of discussion, but what is the correct technique for a snap?

    For an inside snap, I apply rudder a fraction before (same direction) aileron and up elevator.
    For an outside snap, I apply rudder a fraction before opposite aileron and down elevator.

    Problem is, I watch the big boys do snaps on my TOC videos and mine look so raggedy-ass.


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080923/65c0cb18/attachment.html>