[NSRCA-discussion] Servo question

[Jay Marshall]

 Don't forget to check the weights. The BLS 451 are probably heavier.

Jay Marshall

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of
adriancwong at earthlink.net
Sent: Friday, October 10, 2008 2:34 AM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Servo question

Never mind, guess I have found the answer.

I went to the Futaba web site and they listed ratings at both 4.8v & 6V.

Thx again.

-----Original Message-----
>From: adriancwong at earthlink.net
>Sent: Oct 9, 2008 10:57 PM
>To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
>Subject: Re: [NSRCA-discussion] Servo question
>
>To all,
>
>I'm planning to replace my ail servos from Futaba 9154 to BLS 451 -
brushless. In addition, replacing the rud one from 9151 to 9156.
>
>Both the 9154 and 9151 are rated at 4.8v, while the 451 and 9156 are rated
at 6v. Since I'm using a 4 cell, 4.8v rx battery, will there be any problem
on switching servos?
>
>Thx in advance,
>
>Adrian
>_______________________________________________
>NSRCA-discussion mailing list
>NSRCA-discussion at lists.nsrca.org
>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion