[NSRCA-discussion] Cutting CF and FG Panels???

[bill thompson]

I have found the best way to cut C/F is to use a table saw with a Tungsten Carbide tip blade. It gives a very smooth edge and straight.
  ----- Original Message ----- 
  From: krishlan fitzsimmons 
  To: General pattern discussion 
  Sent: Tuesday, May 06, 2008 11:26 PM
  Subject: Re: [NSRCA-discussion] Cutting CF and FG Panels???


  Tungsten Carbide.. With a jig saw.. Super smooth cuts.. 
  Get them at aerospace composites.. http://www.acp-composites.com/acp-ta.htm

  Chris

  Lisa & Larry <lld613 at psci.net> wrote:
    What is the best blade to use on a band saw? It has 2 speeds, what is the best speed (1,450 / 3,000 rpm)?

    I need to cut down two 12 x 24 panels and would like a clean edge ( 1/8" CF/Nomex/CF panel, and a FG/Nomex/FG panel) .

    Nope, don't use the band saw much..

    Thanks,
     
    Larry Diamond
    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion




  Chris 





------------------------------------------------------------------------------
  Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now. 


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080507/c6f11f75/attachment.html