[NSRCA-discussion] Embarrassing Programming Problem

[Ron Van Putte]

Somehow I knew Tony would tell me to use ailevator, but I decided to  
use channels 2 and 6 and now it's a CRUSADE!

Here's a general Futaba question:  Does subtrim carry through  
globally?  I have adjusted the subtrims on elevator and aileron to  
get the servo arms right in neutral, after I got them as close as  
possible mechanically.

Ron Van Putte

On May 5, 2008, at 3:20 PM, Tony wrote:

> Ron:
> Why are you re-inventing the wheel?
> Use the Ailvator pre-set mix for dual elevator servos already built  
> into the
> 9Z..
>
>
> Tony Stillman, President
> Radio South, Inc.
> 139 Altama Connector, Box 322
> Brunswick, GA  31525
> 1-800-962-7802
> www.radiosouthrc.com
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron  
> Van Putte
> Sent: Monday, May 05, 2008 4:09 PM
> To: General pattern discussion
> Subject: [NSRCA-discussion] Embarrassing Programming Problem
>
> I'm setting up a new airplane on my Futaba 9ZAP transmitter and using
> channels 2 and 6 for servos on each elevator half.  I have PMX set
> for channels 2 and 6, mixing channel 2 into channel 6 and everything
> works fine, except the servo on channel 6 only moves about 2/3 the
> throw of the servo on channel 2.  I've tried everything I can think
> of to rectify the problem with no success.  In addition, there's a
> small shift in neutral when going from high rate elevator to low rate.
>
> I started with an unused model in the menu, so I don't think there's
> any hidden programming lurking.
>
> Any ideas?  I'll be very irritated to find there's a simple solution,
> but I'd also be very grateful to have the problem go away.
>
> Ron Van Putte
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion