[NSRCA-discussion] Embarrassing Programming Problem

[Tony]

Ron:
Why are you re-inventing the wheel?  
Use the Ailvator pre-set mix for dual elevator servos already built into the
9Z..


Tony Stillman, President
Radio South, Inc.
139 Altama Connector, Box 322
Brunswick, GA  31525
1-800-962-7802
www.radiosouthrc.com

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron Van Putte
Sent: Monday, May 05, 2008 4:09 PM
To: General pattern discussion
Subject: [NSRCA-discussion] Embarrassing Programming Problem

I'm setting up a new airplane on my Futaba 9ZAP transmitter and using  
channels 2 and 6 for servos on each elevator half.  I have PMX set  
for channels 2 and 6, mixing channel 2 into channel 6 and everything  
works fine, except the servo on channel 6 only moves about 2/3 the  
throw of the servo on channel 2.  I've tried everything I can think  
of to rectify the problem with no success.  In addition, there's a  
small shift in neutral when going from high rate elevator to low rate.

I started with an unused model in the menu, so I don't think there's  
any hidden programming lurking.

Any ideas?  I'll be very irritated to find there's a simple solution,  
but I'd also be very grateful to have the problem go away.

Ron Van Putte
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion