[NSRCA-discussion] Offset Header Needed

[Ron Van Putte]

Thanks.

I could only find one offset header for the OS .61 VF (this is the  
Hanno Special); it was from Macs Products, but only had a lift of 1  
1/2 inches.  I replied to Ihncheol Park, who sent an e-mail to the  
List last night, saying he thought he might have a couple of headers  
with the right lift.   I also sent an e-mail to Karl.

Ron Van Putte

On Jan 2, 2008, at 8:35 AM, Jon Lowe wrote:

> Ron,
> Karl Mueller could make you one in a couple of days.  That is probably
> your only solution.
>
>
> Jon Lowe
>
>
> -----Original Message-----
> From: Ron Van Putte <vanputte at cox.net>
> To: NSRCA Mailing List <nsrca-discussion at lists.nsrca.org>
> Sent: Tue, 1 Jan 2008 11:49 pm
> Subject: [NSRCA-discussion] Offset Header Needed
>
>
>
> I am looking for an offset header for an OS .61VF (rear exhaust)
> engine.  I'd like one with a 2 1/4" vertical offset to use in a
> Thunder Tiger Imagine 50 ARF I just bought.  I haven't found anything
> close.  Any ideas out there?
>
> Ron Van Putte
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
> ______________________________________________________________________ 
> __
> More new features than ever.  Check out the new AOL Mail ! -
> http://webmail.aol.com
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion