[NSRCA-discussion] starter video

[ron at inweldcorp.com]

Kelly;

Nice starter.  I cut my arm this spring reaching across the propeller.
Wish I had used the Smarter Starter.

I can't get the drawings to come up.  For drawing 1, Acrobat says
"unrecoqnized token m0".  For drawing 2 it says "too few operands".  Has
anyone else had this problem?  I have Acrobat 6.0.

Ron Needham

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Kelly
Regan
Sent: Wednesday, September 26, 2007 9:40 PM
To: NSRCA Mailing List
Subject: [NSRCA-discussion] starter video

Guys,
I made a video of my "smarter starter" that I thought you
might like.

I posted it on YouTube:
http://www.youtube.com/watch?v=0q0q5E2IMR4

BTW
Keith, sorry to here about your Brio.  Thank you again
for your help during my build.

-- 
________________________________
Kelly Regan
Home Page: www.reganspace.com
________________________________

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion