[NSRCA-discussion] Airplane angle of attack

rcmaster199 at aol.com rcmaster199 at aol.com
Wed Oct 3 18:03:39 AKDT 2007


Nat,


?


It's good to see your scribble again. It's been awhile


?


Matt










-----Original Message-----

From: Nat Penton 

To: NSRCA Mailing List 

Sent: Wed, Oct 3 6:38 PM

Subject: Re: [NSRCA-discussion] Airplane angle of attack







The primary reason for airliner pencil fuselages is that it is the lightest structure?to?handle repeated pressurizations. For streamline bodies form drag is 80 to 90% skin drag, therefore I suspect drag and lift changes, for?up to plus or minus 3 ? degrees AOA, would be?exceedingly small.


?


It is interesting that airfoils from?9 to18% can have the same drag coefficent. The determinant is primarily leading edge radius.?????????????????????????????????? Nat



----- Original Message ----- 


From: Bob Richards 


To: NSRCA Mailing List 


Sent: Wednesday, October 03, 2007 7:12 AM


Subject: Re: [NSRCA-discussion] Airplane angle of attack







I never meant to draw any conclusion about the knife edge performance of airliners or bombers in my original post. I was merely stating that the reason we PATTERN FLIERS adjust the incidences of the wing and stab (ON OUR PATTERN PLANES) has to do with aerobatic performance. As far as I know, the reason the designers of airliners, bombers, and most full-scale airplanes pick a incidence value has to do mainly with efficiency in cruise.


?


Bob R.






rcmaster199 at aol.com wrote:



I remember watching a clip of a full size multi engine bomber type in test flight. The test pilot banked hard to knife edge near the ground (maybe 500 ft) for some unknown reason and swiftly proceeded to put it in. Don't remember the plane's or test pilot's names. 


?


Full scale fuselages are designed to minimize drag as much as possible (for max range) so they tend to be pencil thin comparatively speaking. Pencil thin fuses do not fly knife flight well nor are they intended to do so. And the higher the weight the worse the problem. At risk of being glib, that test pilot found the outside of the envelope.


?


MattK










-----Original Message-----

From: chris moon cjm767driver at hotmail.com>

To: nsrca-discussion at lists.nsrca.org

Sent: Tue, Oct 2 4:28 PM

Subject: Re: [NSRCA-discussion] Airplane angle of attack







The optimum AOA on airliners is a function of wing design. It's the 

operator's job to try and stay near the optimum AOA for maximum 

efficiency. Lighter gross weights require either higher altitudes or 

lower true airspeed to be most efficient. Likewise, heavier weights will 

have you faster and or lower. I guess what I'm saying is that the 

optimum AOA is essentially dictated by wing design and we juggle the 

other variables in order operate the wing as efficiently as possible. 



I have rolled the 737, 757, 767 and A320 in the simulator and they make 

poor pattern planes. I'm sure there is a significant downgrade for a 

single roll that loses 5000+ feet of altitude. Don't even ask about 

knife edge performance. 



Chris 



Bob Richards wrote: 

> That makes sense to me. The AOA depends on the load. In an extreme 

> case, very lightly loaded, I don't think you would want to fly with 

> the fuselage in a nose down attitude, that would probably be 

> inefficient. Better to have it slightly nose up in cruise with a full 

> load. JMHO. 

> Of course, the reason WE would trim wing incidence would have more to 

> do with overall flight characteristics during aerobatics, particularly 

> with pitch coupling in knife edge flight. 

> Bob R. 

> 

> 

> */chris moon /* wrote: 

> 

> Tried to post this before but it did not go through. 

> 

> The optimum cruise angle of attack for jetliners is somewhere between 

> 2.5 and 5 degrees nose up. Usually closer to 2.5 or 3 degrees for an 

> econ cruise. As fuel burns off and the gross weight goes down, the 

> airplane will need a lower angle of attack to maintain flight which 

> will take us away from our optimum angle (lower). So, we will either 

> climb to where the air is "thinner" and require a higher aoa 

> (angle of 

> attack) to get us back to the 2.5 or 3 degrees or, slow down and 

> maintain the lower altitude thus requiring us to increase the aoa 

> back 

> to optimum. The answer to your question is yes, a jetliner flies at a 

> nose high aoa in cruise. Lift from the fuselage would probably be 

> negligible other than "impact" lift - the force of the relative wind 

> against the raised fuselage bottom. 

> 

> Chris 

> 

> 

> ------------------------------------------------------------------------ 

> 

> _______________________________________________ 

> NSRCA-discussion mailing list 

> NSRCA-discussion at lists.nsrca.org 

> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 







Climb to the top of the charts!? Play Star Shuffle:? the word scramble challenge with star power. Play Now! = 


_______________________________________________  NSRCA-discussion mailing list  NSRCA-discussion at lists.nsrca.org  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion  




Email and AIM finally together. You've gotta check out free AOL Mail!


_______________________________________________

NSRCA-discussion mailing list

NSRCA-discussion at lists.nsrca.org

http://lists.nsrca.org/mailman/listinfo/nsrca-discussion








_______________________________________________

NSRCA-discussion mailing list

NSRCA-discussion at lists.nsrca.org

http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________  NSRCA-discussion mailing list  NSRCA-discussion at lists.nsrca.org  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion  


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - http://mail.aol.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20071004/5136d021/attachment.html 


More information about the NSRCA-discussion mailing list