[NSRCA-discussion] OS 120 Ax bearing replacement

[Ed Alt]

John:
It's the same as other OS motors.  It won't slide easily because of residue build up on the pin, so you might have to either use a solvent to loosen it.  Try to get your finger onto the midpoint of the conrod and push it towards the back as you rotate the crankshaft back & forth.  Eventually it will go.

Ed
  ----- Original Message ----- 
  From: Ron Van Putte 
  To: NSRCA Mailing List 
  Sent: Wednesday, May 30, 2007 10:13 PM
  Subject: Re: [NSRCA-discussion] OS 120 Ax bearing replacement


  I don't know about that motor, but on many motors you have to remove the sleeve so you can get the piston/con rod assembly to move enough toward the back of the motor to get the con rod off the crankshaft. 


  Ron Van Putte


  On May 30, 2007, at 7:23 PM, John Pavlick wrote:


    Has anyone replaced the bearings in their OS 120 Ax? What's the trick? I've done plenty of bearings but this one is different. After removing everything, including the sleeve, I can't slide the rod far enough back to get it off the crankpin. The pin boss in the piston is too narrow to allow the rod to slide far enough. If anyone has done this already I'd appreciate any insight. Thanks!

    John Pavlick
    http://www.idseng.com






------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070531/ad074ec9/attachment.html