[NSRCA-discussion] Ron

[Grow Pattern]

You can replace the Phillips head with an allen head 3-mm bolt. This allows you to tighten without having to put in all that down-force on the screw and whatever is supporting the servo. There is also enough thread in the output shaft allow you to fit a longer bolt for more "security!" 

Regards,

Eric.
  ----- Original Message ----- 
  From: R. LIPRIE 
  To: MATTS NSRCA 
  Sent: Sunday, January 28, 2007 8:39 PM
  Subject: [NSRCA-discussion] Ron


  Hey Ron,  I just wanted to let you know.  I had that thing locktited up.  Just to tell you that I'm not dumb. <G>


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070129/d530b1fb/attachment.html