[NSRCA-discussion] Wing Cores

[jimmy graver]

Jay, I am looking to cut foam wings also this a source I found for foam.  http://www.aircraftspruce.com/catalog/cmpages/styrofoam.php
I buy my spruce from them and there service is good. Hope this helps.
Jimmy Graver
  ----- Original Message ----- 
  From: Jerry Stebbins 
  To: NSRCA Mailing List 
  Sent: Tuesday, December 25, 2007 5:23 PM
  Subject: Re: [NSRCA-discussion] Wing Cores


  Jay, depends on where you are. There are places in/around Atlanta--check with Mike Hester-he buys all the time.ACH foam Technologies.  I just bought 7 sheets in Nashville. Mix of 0.5 and 0.9 oz foam (virgin). Company was EFT Corporation. Might try them.1 615-832-6222.
  Jerry
    ----- Original Message ----- 
    From: Jay Marshall 
    To: nsrca-discussion at lists.nsrca.org 
    Sent: Tuesday, December 25, 2007 3:48 PM
    Subject: [NSRCA-discussion] Wing Cores


    What is a good material and source for wing cores? I have someone to help cut them.



    Jay Marshall 





----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20071226/718b46af/attachment.html