[NSRCA-discussion] Metal Servo Arms

[Ed Alt]

It's not unusual at all for those H9 arms to be really tight.  Usually you
can work the arm off with a pair of channel locks by rocking it gently as
you pull it away.  Just brace the case top close to where the bearing
underneath is seated and you won't hurt anything.

 

Ed

 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of twtaylor
Sent: Thursday, August 30, 2007 7:50 AM
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] Metal Servo Arms

 

I bought some Hanger 9 alum servo arms and when I put them on they are VERY
hard to get to pull down on to the servo. Is this normal? They don't go down
as far as the plastic arms do. They are stamped with a J on the bottom so I
assume they're made for JR servo's.

 

Tim

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070830/6b070d48/attachment.html