[NSRCA-discussion] Brio kit - (was cost of electirc)

[Keith Black]

Kelly, you're lucky your Brio is fairly straight, I'm building my second one
and it's even worse that the first. The stab tube sleeve isn't even located
at the same spot on the two stab halves. One is about 1/16" higher than the
other and the tube angles backwards towards the hinge line much more on one
than the other. I'm going to have to either core out the tube and replace it
or just build a new stab. Since the stab in this kit is 3/4 oz heaver than
the first kit I really ought to build a new one, however, I really hate to
have to do that.

Keith Black

----- Original Message ----- 
From: "Kelly Regan" <kelly.regan2 at verizon.net>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Thursday, September 21, 2006 9:32 PM
Subject: Re: [NSRCA-discussion] cost of electric - now engine choice


> Thank you again everyone,
>
> I have a few more questions about the 140 RX...
>
> What is the part number for the Macs header that will work
> with the Brio?  What about the OS header?
>
> Pipes,  I was confusing the ES Composites and the Aeroslave composite
> pipes....   is 2C140L9 the correct pipe to fit the Brio from ES?
> What about the pipe from Aeroslave? what about the pipe from OS?
>
> Pipe mounts,  what should I be looking for?
>
> Besides central hobbies, any other place I should be looking for a
> good price on the 140RX, headers, or pipes?
>
> Keith,
> I am assuming you are KeithB on RCU, if so I have read your entire
> thread on building the Brio a couple of times...  After seeing you
> pictures and how you had to relocate the wing tubes I started
> measuring...
>
> Everything on the plane I purchased is really close, I even set up a
> transit and looked things over.
>
> -- 
> Kelly Regan
> Visit the Georgetown Branch: http://mysite.verizon.net/vze6uror/
> Freestate Aeromodelers: http://www.freestateaeromodelers.org/
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion