[NSRCA-discussion] Brio Hinges

[Dean Pappas]

Oh yeah ... from the guy who wrote the book!
 

Dean Pappas 
Sr. Design Engineer 
Kodeos Communications 
111 Corporate Blvd. 
South Plainfield, N.J. 07080 
(908) 222-7817 phone 
(908) 222-2392 fax 
d.pappas at kodeos.com 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Mark Atwood
Sent: Monday, November 13, 2006 5:07 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Brio Hinges


Geek

:)


On 11/13/06 5:00 PM, "Scott Smith" <js.smith at verizon.net> wrote:



If you go with CA hinges, make up a little jig as shown in the picture to get all the slots even.  Once covered,  I use the jig again to cut away the covering (that's why it's two sided with the second side a little deeper)  I use the GP hinge machine to cut the initial slot then finish it with a #11 blade.



-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[ mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Richard
Strickland
Sent: Monday, November 13, 2006 10:38 AM
To: 'NSRCA Mailing List'
Subject: [NSRCA-discussion] Brio Hinges



What's the best way to hinge beveled surfaces as on the Brio kit?

Richard

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 


  _____  

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion





-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/ab0f1394/attachment-0001.html 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 16693 bytes
Desc: image.jpg
Url : http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/ab0f1394/attachment-0001.jpe