[NSRCA-discussion] Servo Lead Tubes

[Scott Smith]

Great idea Bob!  I just made a bunch, 1.5gm per 11 inch section.

50mm wide strips seems to be about right (you get 4 per sheet plus a little
left over for a mask on the next step.)  I painted on a 1/4 wide glue strip
of thinned white glue on one edge and let that dry.  After wrapping around
the dowel, hit the seam with the sealing iron and you're done.


-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Bob Kane
Sent: Wednesday, May 24, 2006 6:42 AM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Servo Lead Tubes


I make my own by rolling regular printer paper around
a wood dowel and gluing the edge with some white wood
glue. Just a 1/4" overlap will do.

--- Jerry Budd <jerry at buddengineering.com> wrote:

> Does anyone know of another source for the
> Feather-Lite Servo Lead
> Tubes that Gator R/C was selling?  Or something
> that's a close
> equivalent?
>
> TIA, Jerry
> --
> ___________
> Jerry Budd
> Budd Engineering
> (661) 722-5669 Voice/Fax
> (661) 435-0358 Cell Phone
> mailto:jerry at buddengineering.com
> http://www.buddengineering.com
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>


Bob Kane
getterflash at yahoo.com

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion