[NSRCA-discussion] P-07 question

[Ed White]

Didn't we go through this in P03 on some maneuver where somewhere in  the code it said that if roll direction wasn't specified, and there  were two same kind of rolls in one maneuver, that the rolls had to be  done in opposite directions.
  
  Or am I hallucinating again?
  
  Ed

DaveL322 at comcast.net wrote:    http://www.fai.org/aeromodelling/documents/sc4
   
  Roll direction is not specified - but it must cover 90 degrees of  looping (1/8 of prior loop and 1/8 of following loop) with 90 degrees  of roll completed at the tangent point between loops.
   
  Dave
   
  -------------- Original message -------------- 
From: mike mueller <mups1953 at yahoo.com> 
 Where's  the actual rules book? Also on the Horizontal Eight with intergrated  1/2 rolls does the rolling direction have to be the same on each half?  TIA, Mike    

---------------------------------
  Sneak preview the all-new Yahoo.com. It's not radically different. Just radically better. From: mike mueller <mups1953 at yahoo.com>
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] P-07 question
Date: Fri, 19 May 2006 14:33:50 +0000

  _______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060519/342a8424/attachment.html