[NSRCA-discussion] Brio 10

[Scott Anderson]

Jay,

You should call and talk to Shawn at Castle Creations, he might want to take a look at the controller.

Scott Anderson
D3 AVP
Team Tanicpacks.com
Team Castle Creation
  ----- Original Message ----- 
  From: Jay Marshall 
  To: 'NSRCA Mailing List' 
  Sent: Thursday, May 18, 2006 5:30 PM
  Subject: Re: [NSRCA-discussion] Brio 10


  An update. According to Castle Creations, when the ESC shuts down on an over current condition, it only shuts down the motor, not the BEC. Of course it still remains that I had a massive unknown failure where the ICs floated off of the PC board which would negate any "normal" shutdown.

   

  -----Original Message-----
  From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob Richards
  Sent: Wednesday, May 17, 2006 1:02 PM
  To: NSRCA Mailing List
  Subject: Re: [NSRCA-discussion] Brio 10

   

  Michael,

   

  That was my thought as well. The Hyperion motor I am using pulls 30 amps with a 10x5E, and about 35 amps with a 11x5.5E.  The 10x5 is adequate for pattern work.

   

  Bob R.



  Michael Laggis <fishgod at pobox.mtaonline.net> wrote:

    What it sounds like to me is the Phoenix 25's are being used outside of
    spec. Following threads on RCGroups most of these setups for the brio are
    pulling in the high 20's to high 30 amp range. I believe most would be
    better off with a 35 or 40 amp speed controller.

    Michael 





------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060519/d1236cc2/attachment.html