[NSRCA-discussion] Hysol 9462

[Chris Moon]

Hi Stuart.
    Good to see you back in the pattern game.  Not sure what the problem 
is.  I used some last night and it was fine by this morning and my 
basement is probably cooler than 70 degrees.  Mine was not fully set 
since that takes maybe 24hrs but certainly not anywhere near soft or 
weak enough to move the parts around.  The only thing that I have 
noticed is that a new cartridge will shoot out the sides unevenly until 
the material is "even" inside the cartridge.  Last night I had maybe 2" 
of one side come out before the other (white) side started coming out.  
I don't use the nozzles so I could see that it was not even.
I would scrape off and try again.

Chris

Stuart Chale wrote:
>
> For those who have experience with Hysol 9462, sold as aeropoxy 
> through Bob Violett and others.
>
> I used it last night for the first time.  I have the cartridge system 
> and long mixing applicators.  After about 19 or 20 hours the glue has 
> not hardened.  It has thickened but it is still soft enough to move 
> around.  Is this normal or should I pull the parts apart clean and 
> re-glue?  The application was done in my basement and I am guessing 
> that the temp is about 70 degrees. 
>
> Thanks for any help.
>
> Stuart Chale
>
>  
>
>  
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion