[NSRCA-discussion] Help: Servo pins pulled out of connector body

[paul]

Ed,
    Sounds like I can either get the kit and crimper from Maxx or cut the connector ends off defunct servos / extentions and solder them to the existing servo wires - using heat shrink to keep any flexing away from the solder joints.  Any preference ?
Thanks,
Paul
  ----- Original Message ----- 
  From: Ed Alt 
  To: NSRCA Mailing List 
  Sent: Monday, March 13, 2006 9:24 PM
  Subject: Re: [NSRCA-discussion] Help: Servo pins pulled out of connector body


  Paul:
  Better off to replace the entire connector and pins.  Most likely the plastic housing was damaged from the pin pulling out.  Also, the wire had to get strained where it is clasped by the crimp pins.  Maxx Products sells connector kits, but you need a crimper tool.  

  Ed

  ----- Original Message ----- 
    From: paul 
    To: NSRCA Mailing List 
    Sent: Monday, March 13, 2006 10:13 PM
    Subject: [NSRCA-discussion] Help: Servo pins pulled out of connector body


        I strained my Meridian through a tree, wrecked the plane but the equipment appears OK with the exception of both aileron servos.  When the wings came off the servo connector body stayed in the fuse and the servos wires and pins went with the wings.  
        My question is : can I simply re-insert the servo pins in another connector body (taken from defuct servos or extentions) ?
    Thanks,
    Paul


----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060313/efce3e95/attachment.html