[NSRCA-discussion] Brio Wing Dihedral?

[Lance Van Nostrand]

G,
The Brio wing I am working with is from an unbult kit.  I'm questioning this too, but the plane's a good flier so if this wing is not messed up then it is what it is.  The 7/8" I measured is per panel.  I hope to get confirmation.

--Lance

  ----- Original Message ----- 
  From: george w. kennie 
  To: NSRCA Mailing List 
  Sent: Thursday, June 08, 2006 11:09 AM
  Subject: Re: [NSRCA-discussion] Brio Wing Dihedral?


  That sounds like a lot to me, Lance. Even if that's total (as opposed to per panel), it sounds like a candidate for significant proverse roll couple. The wing would need to be about 3&1/2" below the datum line for that amount, and I certainly don't think that is the case.
  G.



    ----- Original Message ----- 
    From: Lance Van Nostrand 
    To: NSRCA Mailing List 
    Sent: Wednesday, June 07, 2006 10:06 PM
    Subject: [NSRCA-discussion] Brio Wing Dihedral?


    I am measuring 7/8" dihedral on Brio wings.  Is this correct?


----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060609/d079e709/attachment.html