[NSRCA-discussion] Break-in procedure for OS140

[jeffghughes at comcast.net]

I've been running the 4 blade and like it. Very quiet, with good down lines. Also makes the plane react a little smoother over a two blade.

-------------- Original message -------------- 
From: colin chariandy <cchariandy at yahoo.ca> 

I have the 19x10 but I don't think I have enough ground clearance. What's the consensous on the 15.5x12, 4 Blade? I would like to minimise left hand work while maximising speed control.

Colin.

Wayne Galligan <wgalligan at goodsonacura.com> wrote:

2-3 Tanks on the ground then run slightly rich in the air for about 1 gallon. 
On the ground for the first few tanks alterate from a rich needle stting to a good two cyle run for a few seconds then back to rich again.
If you have access to a stainless bearing, replace it before running engine or you will be replacing the original in about 30-50 flights depending.

 Best if you can run on test stand and then you can adjust your pipe while breaking in. On 15% Cool Power and an Aeroslave c.f. pipe I am running the length at about 25-26 inches from center of plug to the main baffle.  My current engine is pulling a 19x10 Mejlik prop but the Lockhart 15.25x10 3-blade is a good choice and the new APC 18.1x10W 2-blade is good also.  Run the low end as rich as it will allow and you will get good downline braking with this setup.

I wasnt so sure about using the Mejlik but after this weekend am convinced.  A few guys from the club commented that the downlines where as slow or the same speed as the upline.  So a big Yeh haa on the setup finally. Very quite too almost ELECTRIC LIKE.  It works good in moderate winds too.  I have yet to run it in winds over 15ish but I can always go to the trusty three blade.

Wayne Galligan

----- Original Message ----- 
From: colin chariandy 
To: NSRCA Mailing List 
Sent: Tuesday, June 06, 2006 7:55 AM
Subject: [NSRCA-discussion] Break-in procedure for OS140


Just got a new OS140. I have'nt broken in one for 5 years...what's the best/current practice for break-in?

Colin.
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 




_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060606/0369be25/attachment.html 
-------------- next part --------------
An embedded message was scrubbed...
From: colin chariandy <cchariandy at yahoo.ca>
Subject: Re: [NSRCA-discussion] Break-in procedure for OS140
Date: Tue, 6 Jun 2006 18:43:12 +0000
Size: 717
Url: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060606/0369be25/attachment.mht