[NSRCA-discussion] Foamy for pattern practice
colin chariandy
cchariandy at yahoo.ca
Tue Jan 10 04:56:27 AKST 2006
My problem is limited thrust. The pack gives me about 5 mins of flight all straight and level. Loops, stall turns etc are out of the question. My auw is probably closer to 8oz so I should not have expected much out of the 340 pack.
Colin.
Tom Simes <nsrca at shinymetalass.com> wrote:
On Sun, 8 Jan 2006 15:38:48 -0500 (EST)
colin chariandy wrote:
> I finally got the F3A flying today ( no snow, no wind, no rain). With
> a Kokam 3S 340 pack I am way short of power. I'll try a 3S 500 next.
> Also, the aft cg limit in the manual (60mm from LE) is still very nose
> heavy. What's the best cg position for pattern?
>
> Thanks
> Colin.
Hi Colin,
When you say that you are short on power, do you mean you lack thrust at
full power or you are just not getting much duration out of the packs?
I know when I started flying my foamie outdoors this winter, I was only
getting 2 - 3 minutes out of a pack that would normally give me 10 - 12
minutes indoors. The duration was so bad I initially thought I had put
a partially discharged pack on the plane. A fellow club member
suggested wrapping my batteries in one or two layers of the 1-2mm foam
packing sheet to help retain a little heat and that brought my outdoor
times back in line with what I was getting indoors. Just FYI, I'm using
2C Kokam 340s Etec 450s on a EPP foamy (4.9 oz. AUP w/340s).
--
Tom
_____________________________________________________________________
| , | Tom Simes
---------(@)--------- AMA 230068
--|-- NSRCA 3830
' nsrca at shinymetalass.com
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
---------------------------------
Find your next car at Yahoo! Canada Autos
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20060110/4f1a246f/attachment.html
More information about the NSRCA-discussion
mailing list