[NSRCA-discussion] Webra Gurus

[Jim Woodward]

Jason,

If the header is cut to 5", it sounds like it was used with the Greve pipe
at one point.  I think I ran the 1.45 at 24.25", and the 1.60 from
24.25-24.75" (straight line distance from plug to first baffle).

Also, consider using a Perry pump if you get any inclination of bizarre fuel
problems.  The Webra's are susceptible to the pump getting hot.

Thanks,

Jim


 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of JShulman
Sent: Friday, August 04, 2006 12:06 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Webra Gurus

Oops, ES-140S pipe

Regards,
Jason
www.jasonshulman.com 
www.shulmanaviation.com
www.composite-arf.com

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of JShulman
Sent: Friday, August 04, 2006 11:56 AM
To: NSRCA
Subject: [NSRCA-discussion] Webra Gurus


Hi All,

Anyone know how long the header/pipe should be on the Webra 145 AeroX? The
header looks short, ~5", and plan on running it with the ES 140D pipe. We
are going to use the standard carb instead of the fancy needle carb.
Anything else we should know about it?

Thanks,
Jason
www.jasonshulman.com
www.shulmanaviation.com
www.composite-arf.com


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion