[NSRCA-discussion] Robart air can leak

[Ken Thompson]

It's made of aluminum, I've already scuffed the area, I will get the JB for 
aluminum and try it out.  I'll just test it out real good before I 
re-install it.

I also got a hint of using Hubba Bubba bubble gum, that sounds like a tasty 
attempt also.

Ken
----- Original Message ----- 
From: "Bob Kane" <getterflash at yahoo.com>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Saturday, April 29, 2006 9:36 PM
Subject: Re: [NSRCA-discussion] Robart air can leak


> What is the can made of?  I think JB Weld would work
> if you get the area clean.
>
> --- Ken Thompson <mrandmrst at comcast.net> wrote:
>
>> Does anybody have any clue how I can repair a
>> pinhole leak in a Robart air cylinder?
>>
>> For some reason there is a tiny leak in the side of
>> the can.  Solder and silver solder won't hold
>> pressure.  I thought about JB weld for aluminum, but
>> I'm not sure that will hold 80 to 100 PSI either.
>>
>> Any hints would be helpful, TIA.
>>
>> Ken> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>>
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
> Bob Kane
> getterflash at yahoo.com
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion