[NSRCA-discussion] Brio 2nds

[Tommy Scarmardo]

I would probably use finishing resin with micro-balloons. You can control how easy it is to sand by how much of the micro-balloons you add to the resin.
   
  tommy s

Richard Strickland <richard.s at allied-callaway.com> wrote:
  I managed to get one of the slightly dented Brios that will take some
filler. The composite material is so thin, however I'm thinking auto filler
will be too hard to sand compared to the structure. (I don't want to
penetrate the gel-cote as there just isn't much there) How about using
model filler and then hardening it up with CA? Any thoughts? Suggestions?

Richard


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


		
---------------------------------
Love cheap thrills? Enjoy PC-to-Phone  calls to 30+ countries for just 2¢/min with Yahoo! Messenger with Voice.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060427/a954d82c/attachment.html