[NSRCA-discussion] Carbon fiber tube push rods

[Jim Oliver]

Thanks for the info.
   
  Jim Oliver

jivey61 at bellsouth.net wrote:
          And if the end trys to splinter a drop of CA will fix it.
   
  Jim Ivey
    ----- Original Message ----- 
  From: jivey61 at bellsouth.net 
  To: NSRCA Mailing List 
  Sent: Sunday, April 23, 2006 9:23 PM
  Subject: Re: [NSRCA-discussion] Carbon fiber tube push rods
  

  Jim
   I use a dremel cutoff wheel. Roll the tube while cutting.Don't breath the dust of course.
  Jim Ivey
    ----- Original Message ----- 
  From: Jim Oliver 
  To: NSRCA-discussion at lists.nsrca.org 
  Sent: Sunday, April 23, 2006 9:03 PM
  Subject: [NSRCA-discussion] Carbon fiber tube push rods
  

  Hey guys,
   
  What is the best way to cut the carbon fiber push rods (hollow tube)?
   
  Thanks,
  Jim Oliver
    
---------------------------------
  Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2¢/min with Yahoo! Messenger with Voice.     
---------------------------------
    
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion    
---------------------------------
    
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

		
---------------------------------
Love cheap thrills? Enjoy PC-to-Phone  calls to 30+ countries for just 2¢/min with Yahoo! Messenger with Voice.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060424/f8b13abd/attachment.html