[NSRCA-discussion] Hatori 821

[Derek Koopowitz]

I'm using the pipe... when you say OD - are you refering to the total
outside diameter of the actual pipe itself?
 
There are 2 sizes - 24mm is the largest and 21mm is the next size down.
You'll see from your pic that the left most side of the pipe has 2 sizes.  I
just gave you both.

  _____  

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Glen Watson
Sent: Tuesday, April 18, 2006 1:52 PM
To: 'NSRCA Mailing List'
Subject: [NSRCA-discussion] Hatori 821



Does anyone know the OD of the inlet on the Hatori 821 muffler?  In addition
I would like to know if anyone has used this muffler with a NMP (Central YS
header)?  If so what ID size tubing (Teflon) did you use to make the
connection between the two?

 

Pic of Hatori attached..

 

Thanks in advance

 

Glen Watson

http://www.geocities.com/rcprecision/pah.html

 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060418/4a9f7da6/attachment.html