Foam for Transmitter Case

[Dave Harmon]

I went to an upholstery shop and bought a block of foam used for sofa
cushions and cut it with a band saw.
Then, I cut in from the side and cut out the outline of the transmitter
and a few pockets for assorted junk.
 
Regards

Dave Harmon
NSRCA 586
K6XYZ[at]valornet[dot]com
Broken Arrow, Ok. 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of AtwoodDon at aol.com
Sent: Tuesday, September 27, 2005 8:04 AM
To: JonLowe at aol.com; discussion at nsrca.org
Subject: Re: Foam for Transmitter Case
 
Jon, try a camera store.  They usually carry foam blocks for use in
camera cases which is basically what our TX cases are.
 
Don Atwood
 
In a message dated 9/27/2005 6:02:27 A.M. Pacific Daylight Time,
jonlowe at aol.com writes:
I'm looking for the grey or black low density open cell foam, a solid 
block, to use in the bottom half of a transmitter case.  I've tried 
McMaster Carr and some other suspects, but short of spending $45, I've 
not found anything.  Anyone have any leads to a low cost source?

Thanks!

Jon Lowe
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050927/f9cb2f38/attachment-0001.html