Webra 1.45 wrist pin removal

[David Wartel]

I've followed directions from previous posts on removing the wrist pin. In fact I removed it for a previous bearing change. Now I'm unable to remove it. I'm using one of the four millimeter bolts threaded into the pin. I've shimmed the piston against the cylinder with popsicle sticks and pulled hard. I then used a longer 4mm bolt and clamped it in a vise and pulled on the engine quite hard; at least as hard as I dare. I've scraped the carbon from the area aft of the pin. Still no luick. (Yes, the circlip is removed.)

Anyone have any other ideas I might try?

Thanks, Dave
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050905/bf710428/attachment.html