JR output arm stabilizers

[Dean Pappas]

Hi Vicente,
Yes. I use a ball link and simple wire linkage to the airframe to accomplish the same thing.
later,
Dean 
 

Dean Pappas 
Sr. Design Engineer 
Kodeos Communications 
111 Corporate Blvd. 
South Plainfield, N.J. 07080 
(908) 222-7817 phone 
(908) 222-2392 fax 
d.pappas at kodeos.com 

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of vicenterc at comcast.net
Sent: Wednesday, November 23, 2005 11:12 AM
To: discussion at nsrca.org; discussion at nsrca.org
Cc: Troy A. Newman
Subject: Re: JR output arm stabilizers


Do we really need this output arm when using JR 8411 in the rudder (pull-pull system)? As far as I know, the main output gear is supported by two ball bearings.  
 
Tahnks,
 
Vicente
 

-------------- Original message -------------- 

I don't think JR makes them anymore but here is one that is the same thing by K+S for Helis:
 
http://www.horizonhobby.com/Shop/ByCategory/Product/Default.aspx?ProdID=KSJ1370
 
Troy

----- Original Message ----- 
From: Ed Alt <mailto:ed_alt at hotmail.com>  
To: discussion at nsrca.org 
Sent: Tuesday, November 22, 2005 8:27 PM
Subject: JR output arm stabilizers

Does anyone know if these are still available?  These were a rectangular metal bracket that went around the servo, over the mounting flanges.  This bracket held a post with a ball end, which connected to a ball ended bolt for the servo arm, via an arm with swivel joints at each end. 
 
Thanks
Ed

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20051123/35b68270/attachment.html